Pagination:«1»
Release:odinmould   Classification:Mould design guide

Runners design

 For most normal injection moulding, runners with a circular (full round) section provide maximum flow.

Main runners should have a cross sectional diameter of 6mm to 12.7mm. Secondary runners should

...

Read More...
Release:odinmould   Classification:Mould design guide

INJECTION MOULD DESIGN

Mould typesTwo-plate, three-plate, hot runner, or runner less moulds can be used with the majority of Engineering Thermoplastic.Two-Plate Mould: The two plate mould is simple in design, yet vers

Read More...
Release:odinmould   Classification:About Mould Steel

TOOL STEEL - P20

TOOL STEEL - P20PLASTIC MOULD STEELRELATED SPECIFICATIONS:Germany W.Nr 1.2738USA AISI P20DESCRIPTION:Plastic mould steel prehardened to 29 – 33HRC. Uniform hardness distributed evenly in large c

Read More...
Pagination:«1»
article.clear
panel.clear