Pagination:«12345»
Release:odinmould   Classification:Mould design guide

injection mould gate design

Gate A small opening which connects the runner and cavity is called as gate. As shown in fig 6, the gate is of pin point, leaving a very negligible mark on the surface of the component. When desi

Read More...
Release:odinmould   Classification:About Gas Assist Injection Molding

How many Stages of Gas Assist Molding

 Stages of Gas Assist Molding

Gas assist molding can be divided into three stages: resin

...

Read More...
Release:odinmould   Classification:About Mould Steel

steel grades 1045

Material No.:1.1730

Designation in:DIN:C 45 U

AFNOR:XC 48

...

Read More...
Release:odinmould   Classification:About Plastic

Polyethylene plastic mould

High-density polythene has been used to manufacture milk crates, bottles, buckets, bowl and gear wheels. It is stiff, hard, can be sterilised and is dense.    

Read More...
Release:odinmould   Classification:About Plastic

PVC plastic

The rigid type is used to make pipes, guttering and roofing. It is very lightweight and is resistant to acids and alkalis.The plasticised type is used for suitcases, hose pipes, electrical wiring and

Read More...
Release:odinmould   Classification:About Plastic

Nylon

Nylon is hard, tough, self-lubricating, has a high melting point and has very good resistance to wear and tear.It has been used to make clothing, bearings and propellers.Image:  

Read More...
Release:odinmould   Classification:About Mould Steel

steel making2

   

Read More...
Release:odinmould   Classification:About Plastic

Clear Acrylic (Perspex)

Clear Acrylic (Perspex) (PMMA) plasticIt was first used to make aircraft canopies. It is ten times more impact resistant than glass. Image: Perspex top of a container Odin Mould Co., Ltd is speci

Read More...
Release:odinmould   Classification:About Plastic

polystyrene (PS)plastic

 What is Expanded polystyrene (PS)plastic?This is used for disposable food packaging, disposable cups, heat insulation and protective packaging for electrical equipment.Image: PS CUP &n

Read More...
Release:odinmould   Classification:Mould design guide

頂出系統设计Mould Ejector System design

頂出系統Ejector System

材料固化時會收縮,這意味著零件會收縮在(形成零件的)公模

仁上。射出成型機上的一些設備是用來自動啟動頂出系統的,

...

Read More...
Pagination:«12345»
article.clear
panel.clear